69MM Dust Shoe | Compatible with 52MM, 65MM & 69MM Router

Very pleased with the dust shoe performance, ease if use and versatility with my dust collection. Highly recommended

Good piece of kit

I recently purchased my Masuter 3, only after a few trial runs I realized I NEEDED dust collection for the chips that came off. This product works great, hardly anything got by it. Required purchase in my opinion.

Works great. Better than I expected.

VERY GOOD PRODUCT

It does what it’s supposed to do, but it’s a little too big. Tends to get in the way - hitting clamps and is prone to bumping the lower Z axis bracket.

I purchased this item as an upgrade to my 4040 XE, having used a similar dust shoe on other machines. It performs as expected. Nicely made, packed well and installs easily. I struggled to find a vacuum hose that would connect the dust shoe to my shop vac, but after several attempts I located one that I could connect using a couple of adapters. Locating an accurate description of hose diameters on the internet is basically hit or miss. Perhaps Fox Alien could also market a hose option for the dust shoe? That would be welcomed.

Over all the dust boot works very well, I gave it only 4 stars because of it's size (height). At times when using a shorter bit the brush gets so close to your work piece that can cause the machine to hang up and possibly skip a step. I had to tweak my router height to compensate for this. Lastly, while it works very well, you have to be mindful of where your work clamps are, I had it bump a hold down and it caused the machine to skip.

Added the dust shoe to my 4040Xe and connected it to a Dewalt Separator and a Rigid 16 gallon vacuum. It was easy to install and does a very good job. Ran it during an 8 hour carve and had little to no clean up afterwards. My only complaint is it makes it hard to see the bits for setup.

It is made ok and meets description at purchase. The vacuum port is much too small and if you make cuts deeper than quarter inch, the fact it is attached to the router really restricts the ability to cut deeper. I would not recommend.